Owner's manual

SLASH 4X4 ULTIMATE
•
11
ESC/Motor Wiring Diagram
TRAXXAS TQ i RADIO & VELINEON POWER SYSTEM
Your model is equipped with the newest TQi 2.4GHz transmitter
with Traxxas Link
™
Model Memory. The transmitter has two
channels for controlling your throttle and steering. The receiver
inside the model has 5 output channels. Your model is equipped
with one servo and an electronic speed control.
MODEL WIRING DIAGRAM
to Motor
LED
EZ-Set Button
(On/Off Button)
Heat Sink
VXL-3s ELECTRONIC SPEED CONTROL
Traxxas High-Current
Connector (Male)
to Battery
Receiver cable
(RX wire)
Cooling Fan
Connector
(for optional use)
TRANSMITTER AND RECEIVER
Steering
Trim
Multi-Function
Knob
Throttle
Trigger
Throttle Neutral
Adjust
Steering Wheel
Power Switch Battery Compartment
Set Button
Menu Button
Red/Green Status LED
see page 33 for more info
Link
Button
LED
Sensor Expansion
Port
**
Traxxas High-Current
Connector (Male)
to Battery
Brushless Motor
(see sidebar for proper
motor wiring)
Channel 1
Steering Servo
Telemetry
Voltage Wire
Telemetry
Temperature Wire
Channel 2
Electronic Speed Control
Cooling Fan
Connector
(for optional use)
RPM
Sensor
Antenna
Motor Cap
V/T - Voltage/Temp Sensor
RPM - RPM Sensor
BAT T /
CH5 - Battery/Channel 5*
CH4 - Channel 4*
CH3 - Channel 3*
CH2 - Speed Control
CH1 - Steering servo
CH1 - Steering servo*
*Not used
** Accessory sensor port for use with the Telemetry Expander Module (see Traxxas.com and included materials for more information)