Owner`s manual
26
•
TR A X X AS
Adjusting Gear Mesh
Incorrect gear mesh is the most common
cause of stripped spur gears. Gear mesh
should be checked and adjusted anytime
a gear is replaced. Access the gears by
removing the single screw on the top
gear cover.
To set the gear mesh, cut a narrow strip
of notebook paper and run it into the gear
mesh of the motor. The motor is mounted
to an aluminum motor mount. Loosen
the single motor mount screw with the
provided 2.5mm wrench to slide the motor
mount. Slide the motor and pinion gear into
the spur gear. Retighten the motor mount
screw and then remove the strip of paper. You should be able to run
a fresh strip of paper through the gears without binding them.
WHEELS AND TIRES
The Slash VXL 4WD and E-Revo VXL use 12mm axle hexes which
allow many types of aftermarket tires and wheels to be adapted
for use on your model. Most will affect the overall width and the
suspension geometry of the model. The offsets and dimensions
designed into the model’s wheels are intentional; therefore,
Traxxas cannot recommend the use of other non-Traxxas wheels
with different specications. Experimentation with different types
of tires is recommended to see which ones work the best on the
terrain where the model is run. Soft compound tires with many
short spikes generally work better on hard, dry surfaces. In loose
dirt, a tire with large spikes should perform better. Foam tires can
be tted for use on pavement or indoor carpet tracks. See your
parts list for accessory wheels and tires.
When selecting tires, consider the overall diameter of the tire.
If the overall diameter is signicantly larger than the stock tire’s
diameter, you will need to use a smaller pinion gear to compensate
for the larger tire. If you wish to install tires with a diameter greater
than 4 inches or 100mm, Traxxas suggests you congure the
transmission for ‘underdrive’ gearing. Details on making this simple
modication are available at Traxxas.com.
Motor Mount
Screw
Do Not Loosen
TUNING ADJUSTMENTS