LaTrax Motor Replacement Instructions

Motor Replacement
1. Unplug and remove the battery from the vehicle.
2. Using a #1 Phillips screwdriver, remove the two 2x8mm
screws from the receiver box cover (A1).
3. Remove the 2x16mm screw from the upper chassis (A2).
4. Remove the 2x8mm and the 2x16mm screws from the
gearbox cover (A3). Lift up on the receiver box cover to
access the 2x16mm screw.
5. Gently lift up on the upper chassis to remove the gearbox
cover (B).
6. Lift straight up on the motor plate to remove the motor/
motor plate from the gearbox.
7. Loosen the set screw on the pinion gear using a 1.5mm
hex wrench (C). Remove the pinion gear from the motor
shaft.
8. Remove the two 3x5mm screws holding the motor to the
motor plate (D).
9. Disconnect the red and black ESC wires from the motor (E).
Discard the motor.
10. Connect the red and black ESC wires to the new motor.
11. Attach the motor plate to the new motor using the two
3x5mm screws.
Note: If you are using the stock pinion gear, keep the locking
plate in place under the top screw (D). If you are using an
optional pinion gear, remove the locking plate to allow proper
adjustment of the gear mesh (F).
12. Insert the pinion gear on the new motor shaft until 1mm
is showing on the outside of the gear (G). Tighten the set
screw on the pinion gear using a 1.5mm hex wrench.
13. Reinstall the motor/motor plate. Be sure the red ESC wire
is on top during installation.
14. Reinstall the gearbox cover. Reinstall the 2x8mm and the
2x16mm screws. Tighten securely.
15. Reinstall the 2x16mm screw in the upper chassis. Tighten
securely.
16. Reinstall the receiver box cover. Reinstall the two 2x8mm
screws. Tighten securely.
Tools needed:
#1 Phillips screwdriver
1.5mm hex wrench
Motor Replacement Instructions
Rev 160304
LaTrax.com
6250 Traxxas Way, McKinney, Texas 75070, Phone: [phone], Fax: [phone], Email: [e-mail]
If you have questions or need
technical assistance, call:
1-888-872-9927
(U.S. residents only)
B
C
E
D
F
Motor wires
Locking plate
G
A
1
1
2
3
3
1mm
ESC wires