User Manual

SLAYER PRO 4X4
•
11
TQ RADIO SYSTEM RULES
Always turn your TQ 2.4GHz transmitter on first and off last. This
procedure will help to prevent your model from receiving stray
signals from another transmitter, or other source, and running out
of control. Your model has electronic fail-safes to prevent this type
of malfunction, but the first, best defense against a runaway model
is to always turn the transmitter on first, and off last.
In order for the transmitter and receiver to bind to one another, the
receiver in the model must be turned on within 20 seconds of turning
on the transmitter. The transmitter LED will flash fast red indicating a
failure to link. If you miss it, simply turn off the transmitter and start over.
Always have the transmitter and receiver turned on before you
start the engine. Never turn the radio system off while the engine is
running. The on/off switch in the model only turns the receiver on and
off. It does not turn off the engine.
Always use new or freshly charged batteries for the radio system.
Weak batteries will limit the radio signal between the receiver
and the transmitter. Loss of the radio signal can cause you to lose
control of your model.
TQ 2.4GHz RADIO SYSTEM BASIC ADJUSTMENTS
Throttle Neutral Adjustment
The throttle neutral adjustment is located on
the transmitter face and controls the forward/
reverse travel of the throttle trigger. Change
the adjustment by pressing the button and
sliding it to the desired position. There are two
settings available:
50/50: Allows equal travel for both acceleration and reverse.
70/30: Allows more throttle travel (70%) and less reverse travel (30%).
50/50 is required setting for the Slayer Pro 4x4 with TRX 3.3
Racing Engine installed.
Steering Trim
The electronic steering trim located on the face of the
transmitter adjusts the neutral (center) point of the
steering channel.
Multi-Function Knob
The Multi-Function knob can be programmed to control
a variety of functions. From the factory, the Multi-
Function knob controls steering sensitivity, also known
as exponential or “expo.” When the knob is turned counterclockwise all
the way to the left (default position), expo is off and steering sensitivity
will be linear (the most commonly used setting). Turning the knob
clockwise will “add expo” and decrease the steering sensitivity in the
initial range of steering wheel travel left or right from center. For more
detail on steering exponential, refer to page 13.
TQ 2.4GHz RADIO SYSTEM CONTROLS
Always turn your
transmitter on rst.
1
2
3
Always turn your
receiver on second.
Then start your engine.
Remember, always turn the
TQ transmitter on rst and
off last to avoid damage to
your model.
7
TRAXXAS TQ 2.4GHZ RADIO SYSTEM
THROTTLE TRIM
100100
00
THROTTLE TRIM
100100
00