TRA37076-74 Rustler VXL Brushless RTR Stadium Truck - Manual

TRAXXAS
•
19
TRAXXAS STABILITY MANAGEMENT (TSM)
Traxxas Stability Management or
TSM allows you to experience all
the speed and acceleration that was
engineered into your Traxxas model
by helping you to maintain control
of the vehicle in low-traction situations. TSM helps provide straight
ahead full-throttle acceleration on slippery surfaces, without
fishtailing, spinouts, or loss of control. TSM also dramatically
improves braking control. High speed cornering and control is also
made possible as TSM makes corrections for you, without intruding
on your fun, or creating unexpected side effects.
The Multi-Function knob on
the TQi transmitter has been
programmed to control TSM.
The recommended (default)
setting for TSM is to rotate the
knob to the 12:00 position (the
zero mark on the dial).
Turn the knob clockwise to
increase assistance; turn the
knob counterclockwise to
decrease assistance. Turn the
knob counterclockwise to its
stop to turn TSM completely off.
Note: TSM is deactivated
automatically when driving or
braking in reverse.
When driving on surfaces with
some traction, decrease the TSM
setting to allow the vehicle to feel more “loose” for power sliding,
drifting, and so on. On surfaces with very little traction (loose dirt,
smooth concrete, ice/snow), increase TSM to maximize acceleration
and control.
Drive with TSM on and off to test how it is making your control of
the vehicle easier and more precise. For more information, visit
Traxxas.com/tsm.
Note: TSM must be completely turned off while adjusting steering
trim.
SETTING UP THE ANTENNA
The receiver antenna has been set up and installed from the factory.
To reinstall the antenna:
Stampede VXL
1. Slide the antenna wire into the
antenna tube to its full extent. When
fully inserted, the wire should reach
to approximately 1/2 inch below the
tube cap. Do not leave any slack in the
antenna wire.
2. Insert the base of the antenna tube
into the molded post on the chassis.
Take care not to crimp the antenna
wire. Do not bend or kink the antenna
wire! Do not shorten the antenna
tube. See the side bar for more
information.
Rustler VXL and Bandit VXL
1. Slide the antenna wire into the bottom
of the antenna tube until the white tip
of the antenna is at the top of the tube
under the black cap.
2. Insert the antenna tube into the mount
while making sure that the antenna
wire is in the slot in the antenna
mount. Take care not to crimp the
antenna wire. Do not bend or kink
the antenna wire! Do not shorten the
antenna tube. See the side bar for
more information.
3. Install the set screw next to the
antenna tube. Use the supplied 1.5mm
wrench to tighten the screw just until
the antenna tube is securely in place.
Do not overtighten.
TRAXXAS TQ i RADIO & VELINEON POWER SYSTEM
To prevent loss of radio range
do not kink or cut the black wire,
do not bend or cut the metal tip,
and do not bend or cut the white
wire at the end of the metal tip.
Correct
NoNo No
Recommended setting
Decrease
assistance
Increase
assistance
TSM off
Antenna
Mount
Antenna
Mount