Owner's Manual

TQi RADIO SYSTEM
•
5
Throttle Neutral Adjustment
The throttle neutral adjustment is located on the transmitter face and
controls the forward/reverse travel of the throttle trigger. Change the
adjustment by pressing the button and sliding it to the desired position.
There are two settings available:
50/50: Allows equal travel for both acceleration and reverse.
70/30: Allows more throttle travel (70%) and less reverse travel (30%).
We strongly recommend to leave this control in its factory location until
you become familiar with all the adjustments and capabilities of your
model.
Note: 50/50 is the default factory setting and the required setting for
Traxxas nitro models. To change the throttle neutral adjust position for
an electric model, turn the transmitter off before adjusting the neutral
position. You will need to reprogram your electronic speed control to
recognize the 70/30 setting.
See your speed control’s instructions.
TQi Radio System Basic Adjustments
Steering Trim
The electronic steering trim located on the face of
the transmitter adjusts the neutral (center) point of
the steering channel.
Note: Traxxas Stability Management (TSM) must be completely turned
off
while adjusting steering trim. See page 8 for TSM adjustments.
Multi-Function Knob
The Multi-Function knob can be programmed to
control a variety of functions. From the factory,
the Multi-Function knob controls
Traxxas Stability
Management (
TSM). For more detail on TSM, refer to page 8.
GETTING STARTED
Traxxas Link Wireless Module and Traxxas Link App
A Traxxas TQi transmitter with the Traxxas Link™ Wireless Module
installed is required to set up Traxxas Stability Management (TSM) for your
specific vehicle model using the Traxxas Link App. The Traxxas Link Wireless
Module (part #6511) is included with the #6507R TQi transmitter (available
separately for easy installation in the #6509R TQi transmitter). The Traxxas
Link App is available in the Apple App Store ΢ or on Google Play™.
If you do not have the Traxxas Link Wireless module installed, then you will
not be able to use the Traxxas Link App to access the specific software for
your model. TSM will function, but it will not be optimized for your model
and you may experience some unexpected behavior from the vehicle. If you
do see undesirable effects, turn the multi-function knob counterclockwise
to reduce TSM’s assistance until you are satisfied with the performance or
turn TSM completely off (see page 8 for additional information).
Receiver Installation
For best performance, it is recommended that the receiver be installed in the
same orientation as the original receiver (with the label facing upward).
Refer to the vehicle owner’s manual for additional information, wiring
diagrams, and detailed instructions on maintaining a watertight seal.
Use double-sided adhesive foam tape to install the receiver into the
receiver box. Once installed, plug the wires into the receiver.