User manual

Page 5 Summit: TQi™ Traxxas Link™ Enabled 2.4GHz Radio (Model 56076-4) Parts List
REV. 210928 1126
5172R
Wheels, SS (Split-Spoke) 3.8" (chrome) (2) (use with 17mm
splined wheel hubs & nuts, part #5353X) (fits Revo®/T-Maxx®/E-
Maxx)
5172
Wheels, SS (Split-Spoke) 3.8" (satin) (2) (fits Revo®/T-Maxx®/E-
Maxx with 6mm axle and 14mm hex)
Transmission Components
4614
Ball bearings (6x12x4mm) (2)
5157
Cov er plates and seals, f orward only conv ersion (Rev ) (Optidriv
blank-out plate, Optidriv e® sensor cover, shift fork cover)
5677A
Cov er, gear/ 3x8mm CS (1)
5677R
Cov er, gear/ 3x8mm CS (1) (f or single motor installation, use with
motor plate #5690X)
3973
Gear set, close ratio (1st speed gear 21T, 18T input gear)
3974
Gear set, wide ratio (1st speed gear 26T, 13T input gear)
3991X
Gearbox halv es (f ront & rear)/ shif t detent ball/ spring/ 4mm GS/ shif t
shaf t seal, glued/ 2.5x8mm CS (2)
3976
Idler gear, 13T (1st speed gear)
3996X
Idler gear, 20-tooth/ idler gear shaft
3992
Input shaf t/ driv e gear assembly (18-tooth steel top gear)
5668
Linkage, shif t (includes: ball collar, spring, ball cup, serv o horn,
linkage wire)/ shif t serv o mount/ 3x8mm BCS (2)
3984X
Output gear, 33-tooth (1)/ spacers (2)
3985X
Output gears, 33T (2)/ driv e dog carrier/ output shaf t spacer
3969
Output shaft, transmission
5690
Plate, motor
5690X
Plate, motor (f or single motor installation, use with gear cov er
#5677R)
3965
Screws, 2.5x8mm cap-head machine (6)
2552
Screws, 3x12mm countersunk machine (6) (hex driv e)
5669
Serv o horn (with built-in spring and hardware) (f or Summit locking
dif f erential)
3989X
Shif t f ork/ shaf t
1647
Silicone grease
5691
Transmission, complete (fits Summit (2-speed))
5692
Two speed conv ersion kit (E-Rev ) (includes wide and close ratio
first gear sets, sub-micro serv o, and linkage) (Requires 3 channel
transmitter)
Traxxas Tools
3433X
Body reamer (aluminum handle)
3433
Body reamer (plastic handle)
3436
Cap, body reamer
3432
Scissors, curved tip
3431
Scissors, straight tip
8712
Speed Bit Essentials Set, hex and nut driver, 7-piece, includes
premium handle (medium), travel pouch, hex drivers (straight:
1.5mm, 2.0mm, 2.5mm) and nut drivers (5.0mm, 5.5mm, 7.0mm,
and 8.0mm), 1/4” drive
8721
Speed bit handle, medium (one piece)
8720
Speed bit handle, premium, large (rubber overmold)
8722
Speed bit handle, premium, medium (rubber overmold)
8710
Speed Bit Master Set, hex and nut driver, 13-piece, includes
premium handle (medium), travel pouch, hex drivers (straight:
1.5mm, 2.0mm, 2.5mm, 3.0mm), (ball-end: 2.0mm, 2.5mm,
3.0mm), and nut drivers (4.00mm, 4.50mm, 5.00mm, 5.50mm,
7.00mm, 8.00mm),
8711
Speed Bit Master Set, hex driver, 7-piece straight and ball end,
includes premium handle (medium), travel pouch, hex drivers
(straight: 1.5mm, 2.0mm, 2.5mm, 3.0mm) (ball end: 2.0mm,
2.5mm, 3.0mm), 1/4" drive
8719
Speed Bit Master Set, nut driver, 6-piece, includes premium
handle (medium), travel pouch, and nut drivers (4.0mm, 4.5mm,
5.0mm, 5.5mm, 7.0mm, 8.0mm), 1/4" drive
8716
Speed Bit Set, hex driver, 2-piece ball-end (2.0mm, 2.5mm), 1/4"
drive
8716X
Speed Bit Set, hex driver, 3-piece ball-end (2.0mm, 2.5mm,
3.0mm), 1/4" drive
8715
Speed Bit Set, hex driver, 3-piece straight (1.5mm, 2.0mm,
2.5mm), 1/4" drive
8715X
Speed Bit Set, hex driver, 4-piece straight (1.5mm, 2.0mm,
2.5mm, 3.0mm), 1/4" drive
3415
Tool set with pouch (includes 1.5mm, 2.0mm, 2.5mm, 3.0mm,
3.5mm, 4mm drivers/ 4mm, 5mm, 5.5mm, 7mm and 8mm nut
drivers/ 2mm, 4mm, and 5mm slotted screwdrivers/ #00 Phillips,
#0 Phillips, and #1 Phillips screwdrivers/ 4mm and 8mm wrench/
driver handle
Turnbuckles & Threaded Rods
5477
Flat wrench, 5mm (blue-anodized aluminum)
5339
Insert, threaded steel (replacement inserts for TUBES) (includes
(1) left and (1) right threaded insert)
5341
Linkage, steering (Rev 3.3) (3x50mm Turnbuckle) (2)/ rod ends
(short) (4)/ hollow balls (4)
5319X
Push rod (aluminum) (assembled with rod ends) (2) (red) (use
with #5359 progressive 3 rockers)
5318X
Push rod (aluminum) (assembled with rod ends) (2) (use with
long travel or #5357 progressive-1 rockers)
5319
Push rod (steel) (assembled with rod ends) (2) (black) (use with
#5359 progressive 3 rockers)
5318
Push rod (steel) (assembled with rod ends) (2) (use with long trav el or
#5357 progressiv e
-1 rockers)
5338
Toe link, 5.0mm steel (f ront or rear) (2)
5338A
Toe links, Revo® (TUBES 7075-T6 aluminum, black) (128mm, fits
front or rear) (2)/ rod ends, rear (4)/ rod ends, front (4)/ wrench (1)
5338R
Toe links, Revo® (TUBES red-anodized, 7075-T6 aluminum,
stronger than titanium) (128mm, fits front or rear) (2)/ rod ends,
rear (4)/ rod ends, front (4)/ aluminum wrench (1)
If you have questions or need technical assistance, call Traxxas at:
1-888-TRAXXAS
(1-888-872-9927) (U.S. residents only)
For orders, calls outside the U.S., and other information, call 972-549-3000,
or fax to 972-549-3011 e-mail Traxxas at support@Traxxas.com
TRAXXAS.com