OWNER’S MANUAL Treasure Cove Fast Action Junior Metal Detector Model TC-1015 GET THE LATEST UPDATED MANUAL FOR THIS PRODUCT BY VISITING US FREQUENTLY AT WWW.TREASURE-COVE.COM Need additional help or parts replacement? treasure-cove.com/support Follow us on Facebook www.facebook.
FEATURES With your Metal Detector, you can hunt for coins, relics, jewelry, gold, and silver just about anywhere. This metal detector is versatile and easy to use. The detector’s features include: Two Operation Modes: ALL METAL, DISC (Discrimination mode) ALL METAL—lets you search for all kinds of metal with auto ground balance and high sensitivity. It’s the best operation mode. DISC (Discrimination mode)—discriminates what kind of metal being detected.
PREPARATION ASSEMBLING THE DETECTOR Assembling the detector is easy and requires no special tools. Just follow these steps. 1. Unscrew the knobs on the search coil and remove the knobs and the connector. Insert the smaller stem and align the holes on the search coil bracket and the stem. Push the connector through the holes, then replace and tighten the knobs. 2. Loosen the stem’s (connected with the handle) lock nut in the direction Lock nut of the arrow.
. Tighten the fixing screw properly. 5. Insert the search coil cable plug into the five pin jack on the front control box’s housing. 6. Lengthen or shorten the stem, so when you stand upright with the detector in your hand, the search coil is level with and about 1~5cm above the ground. After that tighten the lock nut. Caution: The search coil cable plug fits into the connector only one way. Do not force the plug or you could damage it. You don’t need to disassemble the stem lock nut.
the direction of the arrow. 3. Connect the battery with the battery connector taking care of the polarity. Then put the battery into the compartment. 4. Replace the cover. Cautions: Always remove any old or weak batteries as they can leak chemicals that can destroy electronic parts. If you do not plan to use the detector for a week or more, remove the battery. Dispose of old battery promptly and properly.
earphones. Set the volume to the lowest setting before you begin listening. After you begin listening, adjust the volume to a comfortable level. Do not listen at extremely high volume levels. Extended high volume listening can lead to permanent hearing loss. Once you set the volume, do not increase it. Over time, your ears adapt to the volume level, so a volume level that does not cause discomfort might still damage your hearing.
find not only ferrous metal, but also non-ferrous one (see more details below). b. VOLUME—Rotate the control clockwise to power on the unit and adjust the volume. Rotate it fully counter clockwise to power off the unit. c. SENS—Rotate the control clockwise to get higher sensitivity. Rotating it counter clockwise to decrease it. d. LOW BAT—Low battery indicator. When LOW BAT indicator lights, user should replace the battery. e.
A reference for you to know what kind of metal is rejected depending on the DISC (Discrimination mode) setting.
can lower the sensitivity to have better discrimination. CARE AND MAINTENANCE Your metal detector is an example of superior design and craftsmanship. The following suggestions will help you care for your metal detector so you can enjoy it for years. Handle the detector gently and carefully. Dropping it can damage circuit boards and cases and can cause the detector to work improperly. Use the detector only in normal temperature environments.
