Owner's Manual

6mm Hexagon
Wrench
8mm Hexagon Wrench
6mm Hexagon
Wrench
8mm Hexagon Wrench
6mm Hexagon
Wrench
8mm Hexagon Wrench
6mm Hexagon
Wrench
8mm Hexagon Wrench
6mm Hexagon
Wrench
8mm Hexagon Wrench
6mm Hexagon
Wrench
8mm Hexagon Wrench
43
• Remove rotating hub (sold separately) from the main frame of umbrella by removing
the (2) bolts and (2) washers (Fig. 5) from lower backside of umbrella. Set aside bolts and
washers for later use.
• Place rotating hub onto base frame and secure with supplied (5) hub bolts and
(5) washers included with umbrella (Fig. 6).
IMPORTANT: Containers hold up to 230 lbs. of sand. To achieve minimum base weight,
it is necessary to pack sand into all areas of each container and add water.
• Remove cap from add-on weight container (Fig. 7).
• Fill container with 1/2 a bag of sand, approximately 25 lbs. (Fig. 8).
• Tilt container on its side (Fig. 9) and pack sand deep into corners while container is tilted
(Fig. 10).
• Add 1/4 gallon of water. Once water sinks into sand, pack sand down again.
• Add remaining bag of sand to container, while continuing to pack sand down.
• Add another 1/4 gallon water to container. Once water sinks into sand, add additional sand
to container until full.
• Remove/clean excess sand from container cap and threads. Secure cap on container.
• Repeat process with each container.
• Place each add-on weight container back into base frame sections (Fig. 12).
Note:
• Add-on weight containers only fit one direction.
• Carefully place base lid onto base frame (Fig. 13).
• Reattach foot pedal (Fig. 14).
• Your base is now ready for umbrella installation. Please refer to umbrella manual for
installation instructions.
Note:
• You may roll assembled base to desired location prior to installing umbrella onto base.
• Proceed to Step 2 for instructions how to operate rolling base.
(Fig. 5)
(Fig. 6)
(Fig. 7)
(Fig. 8)
(Fig. 9) (Fig. 10) (Fig. 11)
(Fig. 12)
(Fig. 13)
(Fig. 14)
6mm Hexagon
Wrench
8mm Hexagon Wrench