Use and Care Guide

5
SETTING UP YOUR TREBLAB E3
Turn ON
àǘƵȁɐȺǞȁǐɈǘƵǘƵƊƮȺƵɈǏȌȲɈǘƵ˛ȲȺɈɈǞǿƵةȯȲƵȺȺɈǘƵPOWER button for 5 seconds
ɐȁɈǞǶɈǘƵȲƵƮm0(ȺɈƊȲɈȺ˜ƊȺǘǞȁǐخÀǘƵȁȲƵǶƵƊȺƵɈǘƵƦɐɈɈȌȁخÀǘƵƮƵɨǞƧƵɩǞǶǶǐƵɈǞȁɈȌ
pairing mode. For further use, press the POWER button for 3 seconds. You will hear
ɈǘƵٗ§ȌɩƵȲy٘ɨȌǞƧƵȯȲȌǿȯɈةƊȁƮɈǘƵȲƵƮm0(ǶǞǐǘɈɩǞǶǶȺɈƊȲɈ˜ƊȺǘǞȁǐخ
Turn OFF
Press and hold the POWER button for 5 seconds. You will hear the “Power OFF”
ɨȌǞƧƵȯȲȌǿȯɈةƊȁƮɈǘƵȲƵƮm0(ɩǞǶǶ˜ƊȺǘɈɩȌɈǞǿƵȺخ
PAIRING
Make sure TREBLAB E3 are charged and the 3.5 mm Audio cable is not plugged in.
1. Press and hold the POWER button for 3 seconds. You will hear the “Power ON”
voice prompt. Do not release the button for a few additional seconds until you
ǘƵƊȲɈǘƵٗ§ƊǞȲǞȁǐ٘ɨȌǞƧƵȯȲȌǿȯɈةƊȁƮɈǘƵm0(ɩǞǶǶȺɈƊȲɈ˜ƊȺǘǞȁǐȲƵƮǞȁƮǞƧƊɈǞȁǐɈǘƊɈ
the E3 are in pairing mode.
2. Activate Bluetooth mode on your smart device and keep it within 3 feet / 1 m from
the TREBLAB E3 while pairing.
3. Scan/search for available devices in your smart device.
4. Select the TREBLAB E3 from the list.
5. If prompted the password, enter “0000”.
6. Once the E3 are successfully paired and connected, you will hear the “Connected”
ɨȌǞƧƵȯȲȌǿȯɈةƊȁƮɈǘƵm0(ɩǞǶǶȺɈƊȲɈ˜ƊȺǘǞȁǐƦǶɐƵȺǶȌɩǶɯخ
NOTE: The TREBLAB E3 headphones can be connected to only one device
at a time.