Use and Care Guide

SETTING UP YOUR TREBLAB XR800
Turn ON
Press and hold the POWER button for 2 seconds. You will
hear a “Power ON” voice prompt, and the blue & red LED light
will start flashing.
Turn OFF
Press and hold the POWER button for 4 seconds. You will
hear a “Power OFF” voice prompt, and the flashing blue LED
light will go off.
PAIRING
Make sure TREBLAB XR800 is charged and turned OFF.
1.
2.
3.
4.
5.
6.
Press and hold the POWER button on the right earbud.
You will hear the “Power ON” voice prompt, and a few
seconds later - “PAIRING” (LED will flash red and blue
rapidly).
Activate the Bluetooth option on your smart device and
keep it within 3 feet / 1 meter while pairing.
Using your smart device, scan / search for available devices.
Select TREBLAB XR800 from the device list.
If prompted for the password, enter “0000”
Once XR800 is successfully paired and connected, you will
hear a “CONNECTED” voice prompt, and the LED will start
flashing blue every 6 seconds.