Use and Care Guide

RESTORE FACTORY SETTINGS

To restore the earphones back to the factory settings:

Power on XR800

Press and hold the Volume + and the POWER button

for 5 seconds until you hear the double-beep sound and

“Your headset is disconnected” voice prompt. The blue

LED will light up

Now the earphones are restored back to the factory

settings and ready to be paired again.

SAFETY RULES

Don’t disassemble or modify your earbuds for any

reason. Doing this may cause the earbuds to malfunction or

become combustible. The damage to your device can void

the manufacturer’s warranty.

Make sure the headset is completely dry before charging.

Charging a wet device may cause serious damage.

Clean only with a dry cloth.

Avoid exposing TREBLAB XR800 to extreme

temperatures (below 37°F / 3°C or above 112°F / 45°C). Extreme

temperatures can cause deformation of XR800 components

and reduce battery life and the lifespan of your headset.

Don’t put the device's LED lights close to humans’ or

animals’ eyes.

Do not use XR800 during a thunderstorm.

Thunderstorms can cause serious malfunction and increase

the risk of electric shock.