LCT COUNTING SCALE INSTRUCTION MANUAL
USER MANUAL platter into scale memory. 13. LCT COUNTING SCALE Ⅰ. Preparation: [UNIT WEIGHT] KEY is used when setting the known unit weight data into scale in normal operation. 14. Place the scale horizontally and keep the bubble inside the bubble level aligned with the red circle (See Fig.1). [CE] KEY is used for canceling the numeric setting data or cancel the previous unit weight data. 15. [QTY/SET] KEY is used for the alternation of changing normal counting and quantity check operation. 16.
Large heavy gage stainless steel square pan Stability indication you had set, Press [ZERO] to calibrate, after the stable indicator light, press Auto calibration [ZERO] key, the second line of display will show 00000 and now calibration is Auto back light finished. Unit switching kg or lb Variable kg or lb reference weight calibration software 1.
2 Ⅲ. OPERATION: TARE LACK OF SAMPLE Clearing Tare weight: Lack of Sample cursor on the display will turn on if the total weight of sample is Place the empty container on the platter. Press [TARE] key. The WEIGHT display shows below the limit value. The scale will be about to start counting but the error may be 0.00000. high. When the container is removed from the platter, the WEIGHT display will show with minus Press CE key.
“CH=OFF”, it means that the quantity alarm function is turned off. 2. Press [MC] to show the unit which will be cleared. To set the lower and upper count limit, press TARE key to select the hi / lo limits. 3. Press [CE] to confirm clear. For an example, “L = 990”, press 990 on the numeric keypad, then TARE to switch over to “H=1010”, press 1010 on the number keypad. Press QTY/SET to confirm and return to count mode. The alarm will beep at below 990 pcs and at a different tone at 1010 pcs. 3 Ⅳ.
