Installation Manual

Ⅲ. OPERATION:

TARE

Clearing Tare weight:

Place the empty container on the platter. Press [TARE] key. The WEIGHT display shows

0.00000.

When the container is removed from the platter, the WEIGHT display will show with minus

weight value which is the weight of the container.

Clearing the previous tare value:

Remove weight from the platter then press [TARE] key so that the Tare indicator turns off and

WEIGHT display returns to Zero.

SAMPLE SETTING: There are two sample setting methods:

Number setting: (In case of counting the unknown unit weight)

Place the pre-counted X number of samples on the platter, total weight is displayed. Set the X

number of samples through numeric keys and press SAMPLE/UNIT key. UNIT WEIGHT on

display shows the average piece weight of the samples. TOTAL (pcs) on display will show the

number of unit on the scale, add in more samples and it will show the total number of pieces.

Unit weight setting: (In case unit weight is known)

Place samples on the scale. Key in the average piece weight using the numeric keypad. Press

UNIT WEIGHT on the keypad. The total number of pieces will be shown on the TOTAL (pcs).

Add in more units to be counted. Press CE key to clear previous setting.

c. Press [CE] key for cancel the previous unit weight and sample setting.

ALARM FUNCTION: To avoid counting errors, this scale has an useful alarm function to

inform operator of counting error in case of low sample size or low sample weight.

LACK OF SAMPLE

Lack of Sample cursor on the display will turn on if the total weight of sample is

below the limit value. The scale will be about to start counting but the error may be

high.

Press CE key. Use larger sample size (more weight), key in sample size on the

numeric keypad and press SAMPLE/UNIT.

UNIT WEIGHT ENHANCEMENT

The scale will automatically adjust and calculate new average unit weight when

more samples are slowly placed on the scale. This ensures higher accuracy as

samples are now based on a larger population size.

LACK OF PIECE WEIGHT

Lack of Piece Weight indicator will turn on if the averaged unit weight or set unit

weight is not enough for accurate counting operation. Operator may use scale even

this indicator turn on, but counting error might occur.

HI / LO CHECKWEIGHING WITH COUNTING

THE LCS has useful check function to inform operator that the total piece counts

quantity has reached the lower limit and the upper limit desired. This function is

designed for packing applications.

For example, if the operator wish to count 1,000 pieces for every package, he/she

can set the lower limit and the upper limit as 1,000 pieces by:

Press [QTY/SET] enter quantity alarm menu.

Press ZERO to turn on check weighing “CH=ON” on display. Press ZERO, if