Use and Care Guide

ManualsBrandsTreeKeeper ManualsChristmas Tree Storage BagsTK-10105-RS

2 Way Rolling Tree Stand Assembly Instructions

What’s Included:

1 X TreeKeeper Pro stand base (A)

3 X Tree trunk bolts (B)

1 X Screw down collar (C)

1 X Side Castor Wheels* (D)

4 X Locking bottom castors (E)

2 X Wrench (1 for the castors, 1 for the side wheels)

Assembly: (1)Attach the Side Wheels onto the stand using

the 3 provided allen bolts and allen bolt wrench. IMPOR-

TANT: to avoid cross-threading the allen bolts, hold the side

wheel assembly firmly against the stand and line up the

holes. Thread a BOTTOM allen bolt in first, be careful to

continue to hold the assembly tight until the allen bolt is

nearly completely threaded in. Once the allen

bolt is secure, repeat the process for the

second BOTTOM bolt, and then lastly, the

SIDE allen bolt. If at any time you feel

the bolt begin to cross-thread, make

sure you are firmly holding the side

assembly in place. If not properly held

during innstallation, the side assem-

bly could slide from side to side

causing the bolt to cross-thread. If

you feel this occur, unscrew the bolt,

reposition and firmly hold the side

wheel assembly, and try again.

(2) Insert the three tree trunk bolts

into the screw on collar. (3) Using the

included wrench, fasten on the four

castor wheels tightly into each corner of

the stand base.

Attaching your TreeKeeper Bag: If your

TreeKeeper bag is not already attached to the

TreeKeeper Pro base, simply attach the bag to

each of the four legs of the stand with the

Velcro straps. (See your TreeKeeper instruction

sheet for more detailed instructions)

TreeKeeperPro Stand Usage: Place the tree trunk into the

support collar on the stand. Make sure that each collar section is

equally tightened around the trunk of the tree. Each bolt and

collar section needs to be securely tightened around the base of

the tree.

Use the four bottom wheels to easily roll your tree into place.

Once your tree is fully compressed and secured in the TreeKeeper

storage bag, carefully lean the tree to one side and wheel away

using the side castors.

DO NOT lean the tree and pull down stairs. The tree can be heavy

and fall on you AND/OR the bottom castor wheels can be

snapped off as tree is dragged from step to step.

IMPORTANT! Please Read: Be extremely careful when leaning

the tree to the side. As many trees are very heavy, please be

cautious to make sure you can safety maneuver and roll the size

and weight of your stored tree. Also, be cautious in moving the

tree laterally as the tree may tip over. URGENT: Do not attempt to

lean the tree to one side when not properly stored in a

TreeKeeper bag.

*Side castors on TreeKeeperPRO

models only. (Not available on TK

Decorated models).

www.TreeKeeperBags.com