User Manual

ManualsBrandsTrek ManualsEquipment152P-CR-1 Surface_Volume Concentric Ring Probe

Trek Model 152P-CR-1

Surface/Volume Concentric Ring Probe

The Trek Model 152P-CR-1 Concentric Ring Probe is capable of

measuring surface and volume resistance in materials as per IEC

or ESDA standards. A three (3) position switch on the probe selects

surface resistance or volume resistance measurements with

either a guarded or unguarded outer electrode. (See page 2.)

An optional Test Plate Set [CN 17530] consists of two separate

plates. A stainless steel conductive plate can act as a second

electrode to apply the test voltage to the sample under test and

also provides a mini-banana plug connection for a secure ground

connection. An insulative plate is utilized as needed. The use of

these plates are described in the ESD STM11.12 and in IEC 61340-

2-3 standards.

152P-CR-

allows analysis of resistance levels on the human

body [STM 97.1].

The Trek Model 152-1 Resistance Meter used with the

system, is designed to precisely measure surface resistance on a

wide variety of conductive, dissipative, and insulative materials.

The Model 152-1 Resistance Meter employs a measurement

technique which conforms to ANSI/ESD Association standards for

measuring surface resistance, resistivity, and volume resistance

and features exceptional measurement accuracy and wide

3 13

measurement ranges of 10 to 10 ohms using either a point-to-

point probe or the two-point probe. Measured resistance values

are clearly displayed on a high-contrast LCD display. Various

probes are available and accessory options include a Walking Test

Adapter which

Trek MODEL 152-1

Resistance Meter

Measurement Range

3 13

10 to 10 ohms

Probe Electrode Test

Voltage

User selectable for

10 V or 100 V, ±2%.

Test Current Limit

Limited to less than 13 mA

in the 10 V range and less

than 1.7 mA in the 100 V

range.

MODEL 152P-CR-1

Surface / Volume

Resistance Probe

A three (3) position switch

on the probe selects

performance options.

Optional Test Plate Set

These plates provide

additional ESD STM

standard options for

guarded and unguarded

resistance and volume

measurements.

Optional Probe Calibration

Fixture

Provides measurement

accuracy verification of

resistance/resistivity

probes.

Measurement and Power Solutions

www.trekinc.com

Trek Model 152-1

Summary of content (2 pages)

PAGE 1
Trek Model 152P-CR-1 Surface/Volume Concentric Ring Probe Trek MODEL 152-1 Resistance Meter Measurement Range 103 to 1013 ohms Trek Model 152-1 The Trek Model 152P-CR-1 Concentric Ring Probe is capable of measuring surface and volume resistance in materials as per IEC or ESDA standards. A three (3) position switch on the probe selects surface resistance or volume resistance measurements with either a guarded or unguarded outer electrode. (See page 2.
PAGE 2
Model 152-CR-1 Concentric Ring Probe and Test Plate Set The Trek Model 152P-CR-1 Concentric Ring Probe, when used with the Trek Model 152-1 Resistance Meter, is capable of measuring surface and volume resistance in materials as per IEC or ESDA standards. A three (3) position switch on the probe selects for SURFACE resistance measurements or VOLUME resistance measurements either with a GUARDED or UNGUARDED outer electrode.