User manual

EN
12
2) Basic Functions of TrekStor MultiSpeaker
TrekStor Bluetooth® MultiSpeaker 4in1 is a portable Bluetooth® speaker with LED
flashlight, speakerphone and USB charging function. Connected to a Bluetooth®-
enabled mobile phone or other Bluetooth®-enabled devices the TrekStor MultiSpeaker
sets up reliable and fast connections and transmits wireless music and calls. Via the USB
port, any device with USB charging function can be charged.
Load MultiSpeaker
a) Remove the LED-flashlight or the optional speaker from the USB port.
b) Connect the USB cable with the USB port at the MultiSpeaker and either with a
Computer or a USB adapter for the socket. While charging, the red LED stays red
and turns off when the the device is fully charged. After no more than 3 hours the
battery is fully charged.
a
Low Voltage Reminder: The red LED flashes every 3 seconds when Bluetooth® is on and
voltage is low. Please charge the battery to maintain battery efficiency.
i
The maximum battery life is only reached after approximately 10 charging cycles.
i
The device turns off automatically if it is not charged after the "Low Voltage Reminder"
indication shows up.
3) Use MultiSpeaker as a battery charger
a) Remove the LED-flashlight or the optional speakers from the USB port.
b) Connect the USB cable to the MultiSpeaker and connect the other end to other
devices (cellphone, MP3 player etc.)
c) Press the On/Off flashlight button to launch the charging function. When the
green light stays on, your device is being charged via DC 5V.
i
The charging process ends and the green LED turns off when the MultiSpeaker is not
connected to another device or if the device is fully charged.
a
Some devices are programmed to contuinue charging even if the battery is already fully
charged. In this case, the MultiSpeaker loads the battery until the device will be removed
or the battery of the MultiSpeaker is empty.
4) Use MultiSpeaker as a flashlight
a) Make sure the LED-flashlight is completely mounted at the MultiSpeaker.
b) Press the On/Off flashlight button to turn the LED-flashlight on.
c) Press the On/Off flashlight button for 3 seconds to turn on the flash-mode.
d) Press the On/Off flashlight button to turn the LED-flashlight off or remove the
LED-flashlight from the MultiSpeaker.
i
If you use the LED flashlight only in flash-mode, this will increase the battery life.