Manual

14
158823.02
PoE PRO
To switch on the tone generation:
Press the TONE button.
• The currently selected tone type is
generated on the currently selected pins of
the currently selected port.
• Tone generation continues until switched
o or for a maximum of 144 minutes.
To change the port that the tone is
applied to:
Press the relevant port selection button.
• The tone is applied to the selected port
using the tone type and pin settings that
were last used for that port.
To change the pins that the tone is
applied to:
Press the port selection button of the
currently selected port.
• The pins that the tone is applied to change
each time the button is pressed.
To change the tone type:
Press the TONE button.
• The tone type changes each time the
TONE button is pressed.
The tone generation can be controlled
from the far end of the cable, to assist in
confirming that the correct cable has been
traced.
To control the tone generation from
the far end:
Briefly apply a short circuit between any two
wires of the cable.
• The sound of the tone changes.
To switch o the tone generation:
Press and hold the TONE button.
• The tone generation stops and normal
cable testing is resumed.
Release the TONE button.
TONE GENERATION
PoE PRO can be used together with a compatible tone probe (available from TREND
NETWORKS) to identify and trace cables. PoE PRO can generate various types of tone on
various combinations of pins. Choice of tone type and pin connection is best determined by
experiment, to achieve the best results with a particular probe type and in a particular cable
situation.
Shows
Analog
tone type
Shows
tone type
Shows
Digital
tone
type
Shows the
port that
the tone is
applied to
Shows that
tone is being
generated
Shows pins
that tone is
applied to
EN