Installation Guide

Installation Guide
www.trendingaccessibility.com info@trendingaccessibility.com
10
for adjustable fusion shower pan on wood joists
Step 26> > > > > > > >
Apply two coats of liquid waterproofing in
opposing directions to achieve 40 mils. (roughly
the thickness of a credit card)
Make sure that the “V” section of the gasket clamp
is filled with the liquid waterproofing.
Step 27 > > > > > > >
In order to set the correct height of the grate frame,
you may need to use the height extension ring
(see diagram to the right). If the height extension
ring is required, it will need to be fixed to the height
adjustment ring using solvent cement. The grate
frame can now be attached to the height adjustment
or extension ring, depending on tile thickness. This is
done by using firm pressure to clip the components
together; it is a tight fit.
Step 25> > > > > > > >
Continue the application of the liquid waterproofing
membrane. Paint a layer of liquid waterproofing
over all taped joints. It is easiest to begin with the
walls first and then proceed to the floor area. For
consistant application, use a paint roller to apply
waterproofing to all surfaces. Allow the waterproofing
to dry for about 4 hours. After first coat is dry, re-coat
in the opposite direction. If you rolled up and down
for the first coat, roll left to right on the second coat.
“click”
extention ring
adjusting ring
1/4” to 5/8” Tile Height
5/8” - 1” Tile Height
grate frame
grate frame
adjusting ring
Pro-Tip > > > > > > > >
To achive the best results, we recommend
waterproofing the whole room.
The waterproofing must cure for at least 12 hours
before flood testing.
If flood testing, perform test before tiling.
Use modified thinset when placing the tile.