Owner's manual

Installation Guide
www.trendingaccessibility.com [e-mail]
5
for fusion shower pan surface mounted on suboors
Step 5 > > > > > > > >
For your dry run, position the Fusion pan into place
and check to make sure the pan is level. If you
notice any rocking or flexing in the pan, you may
need to shim or shave areas.
Step 6 > > > > > > > >
IMPORTANT: You must sand the top of the pan
lightly with a palm or belt sander to roughen up the
surface for proper adhesion of waterproofing.
Step 7 > > > > > > > >
To prep for permanent installation, remove the Fusion
pan from the surface. Apply a generous amount of
construction adhesive to the subfloor.
Step 8 > > > > > > > >
Carefully set the Fusion pan into place. Drill and
countersink holes in the Fusion pan. Using the 2 ½”
screws provided, attach the pan. Do not aggressively
screw and over tighten, as you may force the pan out
of level.