Owner's manual

Installation Guide
www.trendingaccessibility.com [e-mail]
6
for fusion shower pan surface mounted on suboors
Step 11 > > > > > > > >
You now want to attach the Drain adapter flange
to the Fusion Pan. First apply a bead of caulk to
the underside of the drain adapter flange. Lightly
push the flange into place, and screw it down
using the four ¾” screws provided. Remove any
excess caulk that squeezes out.
membrane clamp
height adjustment ring
Remove the tile height adjustment ring and membrane clamp and
place to one side; these will be required later in the installation.
Step 12 > > > > > > > >
Make your final connections to the drain. First
apply a bead of caulk to the underside of the
strainer body. Pass the strainer through the drain
adapter flange, and tighten. Make sure connection
is snug but do not over tighten.
Gasket Clamp
Adapter Drain Flange
Step 9 > > > > > > > >
On top of existing subfloor and walls install cement
backerboard in preparation for tiling. Make sure
that the top of the backerboard is roughly 1/8”
higher than the Fusion pan. Start with a bed of
thinset using a 1/4” notched trowel. Next, attach
the first layer of
1/2” backerboard with 1 1/4” cement
board screws 8” on center. Then, making sure to
stagger the joints, attach the second layer of 1/2”
backerboard with 1 5/8” cement board screws 8” on
center. Finally, finish the joints with alkali-resistant
mesh tape.
Step 10> > > > > > > >
Check that the Fusion Pan is level on all four sides.
Fill in any gaps around the perimeter of the pan over
1/8” with latex or acrylic caulk.
Do not use 100% silicone.
1/2” backerboard
1/2” backerboard
subfloor
thinset