Quick Installation Guide TE100-S16g TE100-S24g 1.
Table of Contents English 1. Before You Start 2. Hardware Installation 3. LEDs 1 1 2 4 Technical Specifications Troubleshooting 5 6 Version 11.23.
1. Before You Start ENGLISH Package Contents FRANÇAIS TE100-S16g / TE100-S24g ? ? Multi-Language Quick Installation Guide Power Cord ? Rack Mount Kit ? ? A computer with a network adapter installed ? CAT-5, CAT-5e or CAT-6 Network Cable The surface must support at least 1.5 Kg for the Switch ? The power outlet should be within 1.
ÐÓÑÑÊÈÉ 2. Connect a CAT-5, CAT-5e or CAT-6 RJ-45 network cable from the computer to an available Ethernet port on the TE100-S16g/TE100-S24g. ESPAÑOL DEUTSCH 1. Connect the Power Cord to the TE100-S16g/TE100-S24g and then to a power outlet. FRANÇAIS ENGLISH 2.
The switch can be mounted in an EIA standard-size, 19-inch rack, which can be placed in a wiring closet with other equipment. 1. Attach the mounting brackets to both sides of the switch and secure them with the provided screws. 2. Carefully position the switch onto the rack. Align the bracket to the screw holes on the rack, then use the screws provided with the equipment rack to mount the switch.
3. LEDs ENGLISH Power Green: Power is on 100Mbps Green (Solid): Link to another device Green: Connection for the port is 100Mbps (Full/Half) Green (Blinking): Activity is occurring from the link Not Illuminated: Connection for the port is 10Mbps (Full/Half) or nothing is detected on the port.
Technical Specifications Hardware Standards IEEE 802.3 10BASE-T IEEE 802.3u 100BASE-TX IEEE 802.
Troubleshooting After connecting the Switch to a power outlet, the LEDs do not turn on. 1. Check the connection of the power cord to the TE100-S16g/TE100-S24g and the power outlet. 2. Check that the power outlet is receiving power. When I connect a computer to the Switch's port, the Link/ACT LED turns on, but the 100Mbps LED remains off. When the 100Mbps LED is off, the computer's connection speed is 10Mbps. After I connect my PCs to the Switch, I am unable to share files. 1. Check the LEDs on the Switch.
Limited Warranty TRENDnet warrants its products against defects in material and workmanship, under normal use and service, for the following lengths of time from the date of purchase.
WARRANTIES EXCLUSIVE: IF THE TRENDNET PRODUCT DOES NOT OPERATE AS WARRANTED ABOVE, THE CUSTOMER'S SOLE REMEDY SHALL BE, AT TRENDNET'S OPTION, REPAIR OR REPLACE. THE FOREGOING WARRANTIES AND REMEDIES ARE EXCLUSIVE AND ARE IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED, EITHER IN FACT OR BY OPERATION OF LAW, STATUTORY OR OTHERWISE, INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
Certifications This equipment has been tested and found to comply with FCC and CE Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received. Including interference that may cause undesired operation. Waste electrical and electronic products must not be disposed of with household waste. Please recycle where facilities exist. Check with you Local Authority or Retailer for recycling advice.
Product Warranty Registration Please take a moment to register your product online. Go to TRENDnet’s website at http://www.trendnet.com/register Copyright ©2009. All Rights Reserved. TRENDnet.
