Quick Installation Guide TEW-636APB H/W: V1.
Table of Contents Table of Contents English ...................................................................................................... 1. Before You Start ................................................................................. 2. Hardware Installation .......................................................................... 3. Configure the Access Point ............................................................... 1 1 2 3 Troubleshooting ...........................................
1. Before You Start Package Contents TEW-636APB ? User's Guide CD-ROM ? ? Quick Installation Guide AC Power Adapter (12V DC, 1A) ? 1 RJ-45 cable ? Installation Requirements Web Browser: Internet Explorer (5.
2. Hardware Installation Note: Locate an optimum location for the Access Point. The best place for the Access Point is usually at the center of your wireless network. Please connect the computer configuring the TEW-636APB to the same switch/hub. 1. Connect a RJ-45 cable from the Switch/Hub to the LAN port of the Access Point. 2. Connect the AC Power Adapter to the Access Point and then to a power outlet. 3. Verify that the following panel lights are on: Power and WLAN.
3. Configure the Access Point Note: It is recommended that you configure the Access Point from a wired computer. 1. Open your web browser, type http://SCXXXXXX, in the Address bar, and then press Enter. XXXXXX represents the last 6 digits of the Mac Address. You can find the Mac Address on the bottom of the router. 2. Enter the User name and Password, and then click OK. User Name: admin Password: password 3. Click System and then click Basic Settings.
4. Click Wireless and then click Basic Settings. Select the desired Wireless Mode, select Access Point for Operating mode and then click Save. 5. Click Virtual APs. Select a Virtual AP, click Enable and then click Configure. Note: The example below is for WPA-PSK security. If your wireless adapters do not support WPA-PSK, then select WEP. 6. Enter a SSID, select the desired Security System, enter the Network Key, click Save and then click Back. 7. Repeat step 5 and 6 for each subsequent Virtual AP. 8.
9. If desired, enter a new user name, check Change Admin Password, enter a new password, retype the new password and then click Save. By default: User Name: admin Password: password 10. Click Apply and then click Reboot. Note: If you skip this step, any settings that you changed will NOT be saved. Your installation is now complete.
Troubleshooting Q1: I typed http://SCXXXXXX in my Internet Browser's Address Bar, but an error message says “The page cannot be displayed.” How can I get into the TEW636APB's web configuration page? A1: First, check your hardware settings again by following the instructions in section 2. Second, make sure the LAN and WLAN lights are lit. Third, verify the Mac Address of the access point. Look at the bottom of the access point. Copy the last six digits of the Mac Address.
Certifications This equipment has been tested and found to comply with FCC and CE Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received. Including interference that may cause undesired operation. Waste electrical and electronic products must not be disposed of with household waste. Please recycle where facilities exist. Check with you Local Authority or Retailer for recycling advice.
Customer Support Visit www.trendnet.com/support Email: support@trendnet.com Europe (Germany . France . Italy . Spain . Switzerland . UK) Toll Free Telephone: +00800 60 76 76 67 English/Espanol - 24/7 Worldwide Telephone: +(31) (0) 20 504 05 35 English/Espanol - 24/7 Product Warranty Registration Please take a moment to register your product online. Go to TRENDnet’s website at http://www.trendnet.com/register 20675 Manhattan Place Torrance, CA 90501 USA Copyright ©2008. All Rights Reserved. TRENDnet.
