Quick Installation Guide TEW-AO12O
Table ofofContents Table Contents English ................................................................................................................... 1. Before You Start ............................................................................................ 2. Hardware Installation ..................................................................................... 3. Mounting ........................................................................................................
1.
2. Hardware Installation 1. Unscrew the antenna from your wireless access point or wireless router. 2. Attach the blue sleeve (Reverse SMA) end of the jumper cable (provided with the TEW-ASAK) to your wireless access point or router. 3. Connect the black sleeve (N-type) end of the jumper cable to the TEW-ASAK. 4. Connect the other end of the TEW-ASAK to the blue sleeve of the antenna cable (TEW-L406 or TEW-L412).
. Run the antenna cable through the mounting base. 6. Connect the black sleeve (N-type) end of the antenna cable to the TEW-AO12O. 7. Connect the antenna to the antenna base and tighten the screws.
3. Mounting Wall Mounting 1. Slide the mounting brackets through the Antenna base and tighten the screws. 2. Place the antenna base on the desired spot on a wall. Use a pen to mark the spots at each of the four holes. 3. Drill holes for the fastener plugs at the marked positions on the wall. 4. Insert fastener plugs into the drilled holes. 5. Use the provided wood screws to screw the antenna to the fastener plugs to the wall.
Pole Mounting 1. Slide the mounting brackets through the Antenna base and tighten the screws. 2. Slide the two provided u-clamps around the pole. Place the pole mounting bracket at the desire height and position 3. Secure the mounting bracket to the pole mounting bracket using the nuts and washers provided. Register Your Product To ensure the highest level of customer service and support, please take a moment to register your product Online at: www.trendnet.
Troubleshooting Q1: I am unable to connect my antenna to my wireless router or access point. What should I do? A1: The connector type on your wireless router or access point must be reverse SMA male. Contact the manufacturer of your wireless router or access point regarding the antenna connector type.
Certifications This equipment has been tested and found to comply with FCC and CE Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received. Including interference that may cause undesired operation. Waste electrical and electronic products must not be disposed of with household waste. Please recycle where facilities exist. Check with you Local Authority or Retailer for recycling advice.
TRENDnet Technical Support US . Canada Toll Free Telephone: 1(866) 845-3673 24/7 Tech Support Europe (Germany . France . Italy . Spain . Switzerland . UK) Toll Free Telephone: +00800 60 76 76 67 English/Espanol - 24/7 Francais/Deutsch - 11am-8pm, Monday - Friday MET Worldwide Telephone: +(31) (0) 20 504 05 35 English/Espanol - 24/7 Francais/Deutsch - 11am-8pm, Monday - Friday MET Product Warranty Registration Please take a moment to register your product online. Go to TRENDnet’s website at http://www.