Quick Installation Guide: Version v1.0R A

The following are some general wireless tips to help minimize the impact of interference within an

environment.

Assign your network a unique SSID

Do not use anything that would be identifying like “Smith Family Network”. Choose

something that you would easily identify when searching for available wireless networks.

Do not turn off the SSID broadcast

The SSID broadcast is intended to be on and turning it off can cause connectivity issues.

The preferred method of securing a wireless network is to choose a strong form of encryption

with a strong and varied encryption key.

Change the channel

Most wireless access points and routers are defaulted to channel 6. If you have a site survey

tool that will display the channels you can plan your channel selection around neighboring

access points to minimize interference from them. If your site survey tool does not display

the channel try using channels 1 or 11.

Change the channel bandwidth

If you are using an 802.11n router or access point you can also make the following changes.

Change the channel bandwidth to 20/40MHz. This will provide the highest possible

performance using an 802.11n device. Also, if using 802.11n you should be securing the

network with WPA2 security.

Avoid stacking hardware on top of each other to prevent overheating issues

Maintain enough free space around the hardware for good ventilation and airflow. There

should also be plenty of free space around the antennas to allow the wireless signal to

propagate. Please also make sure that the wireless hardware is not placed in any type of

shelving or enclosures.

There are a number of other environmental factors that can impact the range of wireless

devices.

1. Adjust your wireless devices so that the signal is traveling in a straight path, rather than at

an angle. The more material the signal has to pass through the more signal you will lose.

Note: after setting up the SSID, encryption type and encryption key/passphrase, please

make a note of them for future reference. You will need this information to connect your

wireless computers to the wireless router/access point.

Note: Due to Wi-Fi certification considerations if you choose WEP, WPA or WPA2-TKIP

encryption this device may operate in legacy wireless mode (802.11b/g). You may not get

802.11n performance as these forms of encryption are not supported by the 802.11n

specification.

Wireless Tips