User's Guide


ActivateWWANforAuto‐Failover:Withthisfunctionenabled,whentheEthernetWAN
connectionisbroken,thedevicewillautomaticallyactivatetheWWANconnectionand
keepyouconnectedtointernetwiththealternativeWWANbroadbandservice.
Meanwhile,ifthedevicedetectedthattheEthernetWANconnectionisrecovered,your
broadbandconnectionwillbeswitchedtousetheEthernetWANser vice 
PPPoEAccountandPassword:TheaccountandpasswordyourISPassignedtoyou.For
security, this field appears blank. If you don't want to change the password, leave it
blank.
ConnectionControl:Thereare3modestoselect:
Connect‐on‐demand:ThedevicewilllinkupwithISPwhentheclientssendoutgoing
packets.
Auto Reconnect (Always‐on): The device will link with ISP until the connection is
established.
Manually:The devicewillnotmakethelinkuntilsomeoneclickstheconnect‐button
intheStatus‐page.
MaximumIdleTime:theamountoftimeofinactivitybeforedisconnectingyourPPPoE
session.Setittozeroorenable“Auto‐reconnect”todisablethisfeature.
PPPoEServiceName:Optional.InputtheservicenameifyourISPrequiresit.Otherwise,
leaveitblank.
Maximum Transmission Unit (MTU): Most ISP offers MTU value to users. The default
MTUvalueis0(auto).

PPTP


ActivateWWANforAuto‐Failover:Withthisfunctionenabled,whentheEthernetWAN
connectionisbroken,thedevicewillautomaticallyactivatetheWWANconnectionand
keepyouconnectedtointernetwiththealternativeWWANbroadbandservice.
Meanwhile,ifthedevicedetectedthattheEthernetWANconnectionisrecovered,your
19