User's Guide

Setup Wizard
After you log in, the Setup Wizard appears on the screen. It is recommended to
follow the wizard if are setting up the network and configuring the Modem Router
for the first time.
1. Select a PVC (Permanent Virtual Circuit), then click Next.
It is recommended to use the default setting, PVC0, when setting up the
Modem Router for the first time.
2. The information required on the page below can be obtained from your
Internet service provider (ISP). Consult your ISP and do the following:
a. Enter the Virtual Path Identifier (VPI) and Virtual Channel Identifier (VCI).
b. Set the Encapsulation mode, ATMQoS, and Peak Cell Rate.
c. Enable or disable Default VLAN and PPPoE PassThrough.
d. Click Next to continue.