User's Guide
Table Of Contents
- Product Overview
- Wireless Performance Considerations
- Installation
- Configure the Computer
- Log In to the Modem Router
- Menu
- Setup
- Wireless Settings
- LAN
- DHCP Setting
- Time and Date
- Advanced
- Multi-WAN
- Advanced-LAN
- NAT
- Firewall
- DOS Protection
- Packet Filter
- Rules
- Statistics
- Multicast
- Quality of Service (QoS)
- UPnP
- SNMP
- Maintenance
- Remote Access
- TR069 Setting
- Init Script
- SysLog
- Time Schedule
- Firmware Upgrade
- Configuration Backup/Restore
- Ping
- Diagnostics
- Reboot Device
- Status
- Statistics
- Appendix
- Specifications
- Limited Warranty
provided by your ISP. The default VPI is 8.
VCI — Enter the Virtual Channel Identifier (VCI)) setting provided by your ISP. The
default VCI is 36.
Encapsulation — Select LLC (Logical Link Control) or VCMUX (Virtual Circuit
Multiplexing), according to your ISP.
ATMQoS — Select the type of ATM Queue of Service (ATMQoS) specified by your
ISP. Options are: UBR (Unspecified Bit Rate), CBR (Constant Bit Rate), VBR-nrt
(Variable Bit Rate non-real-time), and VBR-rt (Variable Bit Rate real-time).
Peak Cell Rate — This is the maximum rate of cells that you can send. If provided by
your ISP, enter the rate in the field. Otherwise, leave this field to its default setting.
Enable Default Vlan — Select whether to enable or disable VLAN tagging.
PPPoE PassThrough — Select whether to enable or disable PPPoE passthrough.
Internet Settings
DSL lines use different network protocols to establish Internet connection. Ask your
ISP and select the protocol used by your DSL line, options are:
• PPPoE (RFC-2516 PPP over Ethernet)
• PPPoA (RFC-2364 PPP over ATM)
• IPoA (RFC-1483 Routed)
• Dynamic IP Address (IPoEoA/MER (MAC Encapsulated Routed) with DHCP)
• Static IP Address
• Bridge Mode (RFC-1483 Bridged)
• CIP (RFC-1577 Classic IP/ARP over ATM)