User's Guide

Protocol
This section varies depending on the selected network protocol.
PPPoE (RFC-2516 PPP over Ethernet)
If you select PPPoE (Point-to-Point Protocol over Ethernet), the screen below is
displayed.
State of Connection — Select whether to enable or disable this connection.
IPMode of Connection — Select the connection mode, options are:
• Dynamic: Select Dynamic if the IP address can be automatically obtained
from your ISP.
• Static: Select Static if you are required to use a permanent IP address to
connect to the Internet. You must enter the IP Address and Subnet Mask
provided by your ISP.
Name — Enter your desired connection name.
NAT — Select whether to enable or disable NAT (Network Address Translation).
Enable this setting to share one WAN IP address with multiple computers on your
network.
User Name — Enter the user name provided by your ISP.