User guide

TRENDnet User’s Guide

TEW-804UB

5. On your wireless router/access point, push the WPS button.

Note: Typically, the WPS button hold time is 3-5 sec., then release. For TRENDnet

routers/access points, the WPS hardware push button hold time is 3 seconds. If you are

using another brand device, you may need to refer to your device documentation for

WPS operation.

6. On the wireless utility, click Start.

7. Messages will appear utility indicating that the WPS process has been activated and

the status. Wait for the process to complete.

8. If successful, you will see the following message at the top and the connection

information at the bottom of the utility will appear. Click Finish.

Note: If the WPS process fails, you will see the message below and connection

information at the bottom of the utility will not be displayed. You may need to click Back

and attempt the WPS process again. You may need to refer to your wireless

router/access point documentation regarding the operation of WPS.