User's Guide
Table Of Contents
- Table of Contents
- Product Overview
- Router Setup
- Wireless Networking and Security
- Basic
- ADvanced
- Change your router IP address
- Set up the DHCP server on your router
- Set up DHCP reservation
- Manually configure your Internet connection
- Clone a MAC address
- Add static routes to your router
- IPv6 Internet Connection Settings
- Prioritize traffic using QoS (Quality of Service)
- Advanced wireless settings
- Set your router date and time
- Create schedules
- Access Control
- Open a device on your network to the Internet
- Enable/disable Application Layer Gateways (ALG)
- Enable/disable UPnP on your router
- Using External USB Storage
- Print Share Utility Installation
- Router Maintenance & Monitoring
- Change your router login password
- Change your device name
- Change your device URL
- Identify your network on the Internet
- Allow remote access to your router management page
- Reset your router to factory defaults
- Router Default Settings
- Backup and restore your router configuration settings
- Upgrade your router firmware
- Reboot your router
- Allow/deny ping requests to your router from the Internet
- Check the router system information
- Router Management Page Structure
- Technical Specifications
- Troubleshooting
- Appendix
© Copyright 2013 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-812DRU
5
Backward Compatible
Compatible with legacy wireless devices
Targeted Beamforming
Increased real-time performance by directing stronger wireless signals to your specific
location
*For maximum performance of up to 867 Mbps use with a 867 Mbps 802.11ac wireless
adapter
**Maximum wireless signal rates are referenced from IEEE 802.11 theoretical
specifications. Actual data throughput and coverage will vary depending on
interference, network traffic, building materials and other conditions
*** Printer Control Center utility installation required for each computer in order to
access the printer
Product Hardware Features
Rear View
• USB Share Port – Connect a USB storage device to share files across your
network or connect a USB printer to share printers across your network
(Printer Control Center utility required for printer sharing).
• WPS Button (Wi-Fi Protected Setup) – Push and hold this button for 5 seconds
to activate WPS. The Power LED will blink when WPS is activated.
• Gigabit LAN Ports 1-4 – Connect Ethernet cables (also called network cables)
from your router LAN ports to your wired network devices.
• Gigabit Internet Port – Connect an Ethernet cable from your router Internet
port to your modem.
Reset Button (Located on Bottom)
Gigabit LAN
Ports 1-4
Gigabit Internet
Port
USB 3.0 Share
Port
Power Port
WPS Button
On/Off Power Switch
(EU only)