User's Guide
Table Of Contents
- Table of Contents
- Product Overview
- Router Setup
- Wireless Networking and Security
- Basic
- ADvanced
- Change your router IP address
- Set up the DHCP server on your router
- Set up DHCP reservation
- Manually configure your Internet connection
- Clone a MAC address
- Add static routes to your router
- IPv6 Internet Connection Settings
- Prioritize traffic using QoS (Quality of Service)
- Advanced wireless settings
- Set your router date and time
- Create schedules
- Access Control
- Open a device on your network to the Internet
- Enable/disable Application Layer Gateways (ALG)
- Enable/disable UPnP on your router
- Using External USB Storage
- Print Share Utility Installation
- Router Maintenance & Monitoring
- Change your router login password
- Change your device name
- Change your device URL
- Identify your network on the Internet
- Allow remote access to your router management page
- Reset your router to factory defaults
- Router Default Settings
- Backup and restore your router configuration settings
- Upgrade your router firmware
- Reboot your router
- Allow/deny ping requests to your router from the Internet
- Check the router system information
- Router Management Page Structure
- Technical Specifications
- Troubleshooting
- Appendix
© Copyright 2014 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-818DRU
10
Internet Setup Wizard
1. Open your web browser (e.g. Internet Explorer, Firefox, Safari, Chrome, or Opera) and
go to
http://TEW-818DRU or you can access the router management using the IP
address
http://192.168.10.1.
2. Your router will prompt you for a user name and password. For added security, the
router is preconfigured with a unique password. You can find the Password on a
sticker on the side of the router and on the label on the bottom of the router.
3. Enter your Username and Password, select your preferred language, then click Login.
User Name: admin
Password: (xxxxxxxx)
Note: User Name and Password are case sensitive.
4. The wizard will automatically begin when upon your initial setup. Click Next to begin.
5. Select “DHCP Connection (Dynamic IP Address)” and click Next to continue.
Note: Dynamic IP (DHCP) is typical for most Internet services. You can verify your
settings with your Internet Service Provider.
6. Confirm your Internet connection type and wireless interface settings. Click Apply to
save settings.