User's Guide
Table Of Contents
- Table of Contents
- Product Overview
- Router Setup
- Wireless Networking and Security
- Basic
- ADvanced
- Change your router IP address
- Set up the DHCP server on your router
- Set up DHCP reservation
- Manually configure your Internet connection
- Clone a MAC address
- Add static routes to your router
- IPv6 Internet Connection Settings
- Prioritize traffic using QoS (Quality of Service)
- Advanced wireless settings
- Set your router date and time
- Create schedules
- Access Control
- Open a device on your network to the Internet
- Enable/disable Application Layer Gateways (ALG)
- Enable/disable UPnP on your router
- Using External USB Storage
- Print Share Utility Installation
- Router Maintenance & Monitoring
- Change your router login password
- Change your device name
- Change your device URL
- Identify your network on the Internet
- Allow remote access to your router management page
- Reset your router to factory defaults
- Router Default Settings
- Backup and restore your router configuration settings
- Upgrade your router firmware
- Reboot your router
- Allow/deny ping requests to your router from the Internet
- Check the router system information
- Router Management Page Structure
- Technical Specifications
- Troubleshooting
- Appendix
© Copyright 2014 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-818DRU
16
PBC (Software/Virtual Push Button)
Wireless (2.4GHz or 5GHz)> WPS
In addition to the hardware push button located physically on your router, the router
management page also has push button which is a software or virtual push button you
can click to activate WPS on your router.
1. Log into your router management page (see “
Access your router management page”
on page 17).
2. Click on the Advanced tab.
3. Select wireless band you would like to configure, Wireless 2.4GHz or Wireless 5GHz
and click on WPS.
4. To add a wireless device to your network, simply click the Add Enrollee button in the
router management page, then push the WPS button on the wireless device (consult
wireless device’s User’s Guide for length of time) you are connecting.
PIN (Personal Identification Number)
Wireless (2.4GHz or 5GHz)> WPS
If your wireless device has WPS PIN (typically an 8-digit code printed on the wireless
device product label or located in the wireless device wireless software utility), you can
use this method.
1. Log into your router management page (see “
Access your router management page”
on page 17).
2. Click on the wireless band Wireless (2.4GHz or 5GHz) you would like to configure and
click on WPS.
3. Next to Station PIN, enter the WPS PIN of the wireless device you are connecting and
click the Add Enrollee button.
Note: You may need to initiate the WPS PIN on your wireless device first when using
this method. Refer to your wireless device documentation for details on the
operation of WPS.