User's Guide
Table Of Contents
- Table of Contents
- Product Overview
- Router Setup
- Wireless Networking and Security
- Basic
- ADvanced
- Change your router IP address
- Set up the DHCP server on your router
- Set up DHCP reservation
- Manually configure your Internet connection
- Clone a MAC address
- Add static routes to your router
- IPv6 Internet Connection Settings
- Prioritize traffic using QoS (Quality of Service)
- Advanced wireless settings
- Set your router date and time
- Create schedules
- Access Control
- Open a device on your network to the Internet
- Enable/disable Application Layer Gateways (ALG)
- Enable/disable UPnP on your router
- Using External USB Storage
- Print Share Utility Installation
- Router Maintenance & Monitoring
- Change your router login password
- Change your device name
- Change your device URL
- Identify your network on the Internet
- Allow remote access to your router management page
- Reset your router to factory defaults
- Router Default Settings
- Backup and restore your router configuration settings
- Upgrade your router firmware
- Reboot your router
- Allow/deny ping requests to your router from the Internet
- Check the router system information
- Router Management Page Structure
- Technical Specifications
- Troubleshooting
- Appendix
© Copyright 2014 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-818DRU
38
4. Click on Enabled under Gaming Function section.
5. Review the virtual server settings. Click Apply to save settings.
• LAN IP Address: Enter the IP address of the device to forward the port (e.g.
192.168.10.101).
• TCP Ports to Open: Enter the TCP port you would like to set.
• UDP Ports to Open: Enter the UDP port you would like to set.
Note: Please refer to the device documentation to determine which ports and
protocols are required. You should assign a static IP address to the device or use
DHCP reservation to ensure the IP address of the device does not change.
• Schedule: Select the defined schedule you would like to have the rule to be applied
(see “
Create Schedule” section on page 33).
• Enabled: Selecting Enabled turns on the virtual server and selecting unchecking
disables the rule.
Enable/disable Application Layer Gateways (ALG)
Advanced > Firewall > ALG
You may want to configure your router to allow computers the use of specific high layer
applications or service sessions to pass through. Application Layer Gateways (ALG)
allows you to easily enable or disable these applications to pass through your router.
Note: It is recommended to leave these settings enabled.
1. Log into your router management page (see “
Access your router management page”
on page 17).
2. Click on the Advanced tab.
3. Click on the Firewall section and click on Special Applications.
4. Review the applications to enable or disable. Click Apply to save the changes.
• Email Receiving (POP3): Allows POP3 protocol through your router.