User's Guide
Table Of Contents
- Product Overview
- Router Installation
- Basic Router Settings
- Access your router management page
- Saving and applying router configuration changes
- Change your administrator password
- Set your router date and time
- Create time schedules
- Change LAN IPv4 address settings
- Configure LAN IPv4 DHCP server settings
- Add static DHCP reservations
- Add static host name entries
- Add static ARP entries
- Configure WAN1 / WAN2 interfaces for Internet connectivity
- IPv6 settings
- Virtual LANs (VLANs)
- Application layer gateway (ALG)
- UPnP and NAT-PMP
- Static routes
- Dynamic routing protocols
- Quality of Service (QoS)
- Dynamic DNS
- File sharing server
- Wake on LAN (WoL)
- Wireless Networking and Security
- Wireless Settings
- How to choose the type of wireless security
- Secure your wireless network
- Guest Network
- WiFi client bridge mode
- Connect wireless devices using WPS
- Steps to improve wireless connectivity
- General settings
- Port forwarding rules
- Port trigger rules
- IP filtering
- MAC filtering
- Denial of service (DoS) prevention
- DMZ Host
- One-to-One NAT
- RADIUS Authentication
- Multiple WAN Management Settings
- Setup your router with Router Limits
- Router Limits Content Management
- Creating a Virtual Private Network (VPN)
- PPTP VPN Server
- L2TP VPN Server
- IPsec (Internet Protocol Security)
- Secure Socket Layer VPN (SSL) / OpenVPN
- Certificate Management
- Managing access to the router management interface
- Diagnostic tools
- Backup and restore your router configuration settings
- Reboot your router
- Scheduled automatic reboot
- Console access
- Command Line Interface
- Router Default Settings
- Reset your router to factory defaults
- Upgrade your router firmware
- Ping Watchdog
- Check the router status information
- View routing table and ARP entries
- View your router logging
- Technical Specifications
- Appendix
© Copyright 2019 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-829DRU
6
12. To configure your WAN1 Internet connection settings, click Network and click
WAN1.
13. Under Common Configuration and General Setup, click the Protocol drop-down list
and select the appropriate protocol (Static address, DHCP client, PPTP, PPPoE, L2TP) for
yoru Internet connection. DHCP client is the typical protocol in which the connection
settings are automatically obtained by your ISP (Internet Service Provider). If you are
unsure about the Internet connection settings, please contact your ISP for details. After
you have completed the Internet connection settings, click Apply to save and commit
the changes.
14. To configure your wireless network name/SSID and wireless encryption settings,
click Network and click the wireless band you would like to configure. Wireless 2.4GHz,
Wireless 5GHz1, or Wireless 5GHz2.
Note: By default, the wireless network name/SSID has been pre-configured for your
convenience and can be located on the included wireless settings sticker or on the device
label located on the bottom of the router. If you are modifying the wireless settings, you
will need to connect to the router with your WiFi clients using the new settings.