User's Guide
Table Of Contents
- Product Overview
- Router Installation
- Basic Router Settings
- Access your router management page
- Saving and applying router configuration changes
- Change your administrator password
- Set your router date and time
- Create time schedules
- Change LAN IPv4 address settings
- Configure LAN IPv4 DHCP server settings
- Add static DHCP reservations
- Add static host name entries
- Add static ARP entries
- Configure WAN1 / WAN2 interfaces for Internet connectivity
- IPv6 settings
- Virtual LANs (VLANs)
- Application layer gateway (ALG)
- UPnP and NAT-PMP
- Static routes
- Dynamic routing protocols
- Quality of Service (QoS)
- Dynamic DNS
- File sharing server
- Wake on LAN (WoL)
- Wireless Networking and Security
- Wireless Settings
- How to choose the type of wireless security
- Secure your wireless network
- Guest Network
- WiFi client bridge mode
- Connect wireless devices using WPS
- Steps to improve wireless connectivity
- General settings
- Port forwarding rules
- Port trigger rules
- IP filtering
- MAC filtering
- Denial of service (DoS) prevention
- DMZ Host
- One-to-One NAT
- RADIUS Authentication
- Multiple WAN Management Settings
- Setup your router with Router Limits
- Router Limits Content Management
- Creating a Virtual Private Network (VPN)
- PPTP VPN Server
- L2TP VPN Server
- IPsec (Internet Protocol Security)
- Secure Socket Layer VPN (SSL) / OpenVPN
- Certificate Management
- Managing access to the router management interface
- Diagnostic tools
- Backup and restore your router configuration settings
- Reboot your router
- Scheduled automatic reboot
- Console access
- Command Line Interface
- Router Default Settings
- Reset your router to factory defaults
- Upgrade your router firmware
- Ping Watchdog
- Check the router status information
- View routing table and ARP entries
- View your router logging
- Technical Specifications
- Appendix
© Copyright 2019 TRENDnet. All Rights Reserved.
86
TRENDnet User’s Guide
Limited Warranty
9. At the prompt to install the TAP-Windows adapter, click Install.
10. At the installation completion window, click Next.
11. Make sure to uncheck the “Show Readme” and “Start OpenVPN GUI” options and
click Finish.
12. Copy the client configuration file(s) (client.ovpn) downloaded from the router to the
following path without any sub-folders.
C:\Program Files\OpenVPN\config