1. Before You Start Package Contents ~TFC-1000MSC. +Quick Installation Guide + Power Adapter (5V DC, 1A) Environmental Requirements »operating Temperature: 104 °F} Storage Temperature: (-13— 158 *F) + Humidity: Max. 90% (non-condensing) Note: Environment must be free from strong electromagnetic field generators (such as motors}, vibration, dust and direct exposure to sunlight.
2. Hardware Installation Installing Two Stand Alone TFC-1000MSC Fiber Converters 1. Connect a network cable from a Gigabit port of the TFC-1000MSC to 2 Gigabit port on your switch (e.g. CHG-524Dg, CHG-516Dg). Converter 1 2. Connect the two flora converters with a fiber cable. Note: The TX cable of one fiber converter must be plugged Into the RX port of the second converts.
3. Supply power by connecting the Included adapter to the back of each fiber converter and plug Into an outlet. Installing a TFC-1000MSC In a TIC-1600 Chassis 1. Unscrew the bay cover from the desired bay on the chassis. 2. Remove the TFC-1000MSC by unscrewing the thumbscrew and pulling the unit away from the metal casing.
3. Slide the Fiber Converter Into an available slot and fasten the thumbscrew. 4. Connect a network cable from the Gigabit port of the fiber converter to a Gigabit port on your switch. From hare, you can connect to another fiber converter or any device with a Gigabit port and fiber port. Node: When connecting twa fiber converters, the TX cable of one fiber converter must be plugged into the RX port of the second converter. 3.
LL CF Enable LL CF Disable bar Forced Mode Fiber Auto-Negotiation 1. DIP switch settings can be changed at any time. Users can either (1) unplug the power supply, change the DIP switch settings, and plug In the power supply; or (2) change the DIP switch settings and power cycle the device. 2. The default setting on Dip Switch 2 Is set to “Off" (Auto-Negotiation) position. Put In “On” position only when the other end of the fiber converter Ia required to use Force mode. 3.
