Quick Installation Guide

Wall Mounting Instructions
1. Attach the wall mount plates to the fiber converter.
2. Mount the unit.
Safety Note
Ÿ Turn off the power before connecting any module or wire. The correct
power supply voltage (12 - 60 V DC or 18 - 36 V AC) is listed on the
product label. Check the voltage of your power source to make sure
that you are using the correct part. Do NOT use voltage greater than
12 - 60 V DC or 18 - 36 V AC, the product label.
Ÿ Calculate the maximum possible current in each power wire and
common wire. Observe all electrical codes dictating the maximum
current allowable for each wire size. If the current surpasses the
maximum ratings, the wiring could overheat, causing serious
damage to your equipment.
!
3