Operation Manual

11
Following are the steps to properly connect your TDM-C504 4-PORT ADSL 2/2+ Modem Router by
Ethernet Cable (RJ-45):
1. Turn off your computer/notebook.
2. Connect the ADSL port of your TDM-C504 4-Port ADSL2/2+ Modem Router to the wall jack of the
ADSL/ADSL2/ADSL2+ Line with a RJ-11 cable.
3. Connect the Ethernet cable (RJ-45) from your TDM-C504 ADSL2/2+ Modem Router to the
Ethernet Adaptor on your computer.
4. Connect the Power adaptor to the TDM-C504 ADSL2/2+ Modem Router and plug it into a Power
outlet.
5. Turn on your computer.
6. Refer to the next section to setup or configure your system’s Network Adaptor.
The Power light will be on after turning on the TDM-C504.
!
Use the Power Adaptor exclusively in combination with the equipment
supplied and do not use any other kind of power adaptor for the
equipment.
!