User's Guide

Table Of Contents

TRENDnet User’s Guide

Web Smart Switch Series

Administration

Change administrator password and add accounts

System > Administration

This section explains how to change the administrator password create additional

administrative user accounts for access to the switch management page.

1. Log into your switch management page (see “Access your switch management page”

on page 5).

2. Click on System, and click on Administration.

3. Review the settings.

To change the administrator password, in the “admin” entry in the table, click on

Modify. Note: This default administrator account cannot be deleted.

In the Password field, enter the new password and enter the new password again the

Confirm Password field to verify. Then, click Apply.

Note: The password consists of up to 20 alphanumeric characters.

To create additional administrative user accounts:

 User Name: Enter the user name of the new account.

 Password: Enter the password for the new acocunt and enter the password

again the Confirm Password field to verify. Then, click Add to add to the table.

For additional user accounts, you will be provided the option to Modify or

Delete to remove the account.

Note: The password consists of up to 20 alphanumeric characters.

4. At the bottom of the left hand panel, click Save.

5. Select the Config you would like to save the settings to, click Save Settings to Flash,

then click OK.

Note: This step saves all configuration changes to the NV-RAM to ensure that if the

switch is rebooted or power cycled, the configuration changes will still be applied.