User's Guide

© Copyright 2018 TRENDnet. All Rights Reserved.
17
TRENDnet User’s Guide
Web Smart Switch Series
Timeout
Change web idle login timeout settings
System > Timeout
This section explains how to modify the switch management page idle timeout settings.
1. Log into your switch management page (see “Access your switch management page”
on page 5).
2. Click on System, and click on Timeout.
3. Review the settings. Click Apply to save changes.
 Web Idle Timeout - Enter the idle period in minutes, when the switch will
automatically log out a user from the switch management page.
4. At the bottom of the left hand panel, click Save.
5. Select the Config you would like to save the settings to, click Save Settings to Flash,
then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
System Time
Set the switch date and time
System > System Time
1. Log into your switch management page (see “Access your switch management page”
on page 5).
2. Click on System, and click on System Time.
3. Review the settings. Click Apply to save changes.
 Clock Mode - Displays if system time and date is set manually Local Time or
obtained automatically from a network time server SNTP.
 Current Time – Displays the current system time and date.
 Time Zone – Displays the current system time zone.
 Clock Mode: Select Local Time to manually configure your date and time
settings or select SNTP to configure your switch to automatically obtain
settings from a network time server.
o Local Time – Allows you to manually set the time settings. If selecting
this option, under Local Time Settings, manually enter your date and
time settings.
 Date Settings – Enter your date settings (YYYY/MM/DD).
 Time Settings – Enter your time settings (HH:MM:SS)