User's Guide

TRENDnet User’s Guide

Web Smart Switch Series

View

System > SNMP > View

The SNMP View table specifies the MIB object access criteria for each View Name. If the

View Name is not specified on this page, then it has access to all MIB objects. You can

specify specific areas of the MIB that can be accessed or denied based on the entries in

this table. You can create and delete entries in the View table.

1. Log into your switch management page (see “Access your switch management page”

on page 5).

2. Click on System, click on SNMP, and click on View.

3. Review the settings.

Creating SNMP View Table Entries

This procedure explains how to create entries in the SNMP View Table.

• Enter the View Name. This entry must be pre-defined on the SNMP

User/Group page.

• Enter the Subtree OID.

• Enter “1” for the OID Mask.

• Enter the View Type. Choose from the following options, and then click Add.

o Included: This selection allows the specified MIB object to be included

in the view.

o Excluded: This selection blocks the view of the specified MIB object.

Modifying SNMP View Table Entries

If you need to modify an entry in the View Table page, you must first delete the entry

and then re-enter it.

Deleting SNMP View Table Entries

In the Action column of the table, click Delete for the View table entry that you want to

remove.

4. At the bottom of the left hand panel, click Save.

5. Select the Config you would like to save the settings to, click Save Settings to Flash,

then click OK.

Note: This step saves all configuration changes to the NV-RAM to ensure that if the

switch is rebooted or power cycled, the configuration changes will still be applied.