User's Guide

TRENDnet User’s Guide

Web Smart Switch Series

User

System > SNMP > User

An SNMP User Name and Group Name definition is the basis for all the other SNMP

tables. You can create and delete View Names by following the procedures in the

following sections:

1. Log into your switch management page (see “Access your switch management page”

on page 5).

2. Click on System, click on SNMP, and click on User.

3. Review the settings.

Creating SNMP User and Group Names

Note: There are no default User Names or Group Names defined for SNMP.

• Type a new User Name. Enter a name up to 32 characters in length.

• Type a new Group Name. Enter a name up to 32 characters in length.

• From the SNMP Version pull down menu, select v3. The encryption check-box

becomes active.

o Check the encryption check-box. The Auth-Protocol, Priv-Protocol,

and associated password fields become active.

• Select one of the following choices for the Auth-Protocol field:

o MD5 - The MD5 authentication protocol. SNMP Users are

authenticated with the MD5 authentication protocol after a message

is received.

o SHA - The SHA authentication protocol. Users are authenticated with

the SHA authentication protocol after a message is received.

• Enter the password for the Auth-Protocol.

• Select one of the following choices for the Priv-Protocol field:

o DES - Specifies DES encryption scrambles the SNMP data so that

outside observers are prevented from seeing the data content.

o none - Specifies no encryption is applied to SNMP data.

• Click Add. The new User Name and Group Name are displayed on the SNMP

User/Group page.

Modifying SNMP User and Group Names

If you need to modify an entry in the SNMP User/Group page, you must first delete the

entry and then re-enter it.

Deleting SNMP User and Group Names

In the Action column of the table, click Delete for the User Name and Group Name that

you want to remove.

4. At the bottom of the left hand panel, click Save.

5. Select the Config you would like to save the settings to, click Save Settings to Flash,

then click OK.