User's Guide

TRENDnet User’s Guide

Web Smart Switch Series

Router Ports

Network > IGMP Snooping > Router Port

1. Log into your switch management page (see “Access your switch management page”

on page 5).

2. Click on Network, click on IGMP Snooping, and click on Router Port.

3. Review the settings. Click Apply to save the settings.

In the VLAN ID router port list, you can configure your Static and Dynamic Router ports.

IGMP Snooping Router Port configured manually is a Static Router Port, and a Dynamic

Router Port is dynamically configured by the Switch when a query control message is

received.

To modify an entry, click Modify to add statically add router ports.

Check the static router ports to add and click Apply to save the settings.

Note: You can click on All to add all ports. Clicking Restore will restore the static router

port settings to default.

4. At the bottom of the left hand panel, click Save.

5. Select the Config you would like to save the settings to, then click Save Settings to

Flash.

Note: This step saves all configuration changes to the NV-RAM to ensure that if the

switch is rebooted or power cycled, the configuration changes will still be applied.