User's Guide

© Copyright 2020 TRENDnet. All Rights Reserved.
80
TRENDnet User’s Guide
Web Smart Switch Series
Note: Link Layer Discovery Protocol for Media Endpoint Devices (LLDP- MED) is not
supported on the switch. Each IP phone that is VLAN aware should be manually
configured for the VLAN ID that matches your voice VLAN ID. Each of the voice VLAN
ports connected to an IP phone should be configured as “Not Member” ports of the
tagged VLAN.
Settings
Network > Voice VLAN > Settings
Note: Prior to configuring your voice VLAN, you must first configure a tagged VLAN. This
VLAN will be used as a basis for your voice VLAN.
1. Log into your switch management page (see “Access your switch management page”
on page 5).
2. Click on Network, click on Voice VLAN, and click on Settings.
3. Review the settings.
Use the following procedure to configure voice VLAN:
• From the Voice VLAN field at the top of the page, select one of the following
radio button choices:
o Enable - The voice VLAN feature is active. The other parameter fields
in the voice VLAN Global Settings section become active and are
eligible for data to be entered.
o Disable - The voice VLAN feature is inactive. The other parameter
fields in the voice VLAN Global Settings section become inactive and
are greyed out so that data cannot be entered.
• In the Voice VLAN Global Settings section, enter the configuration information
for the following parameters:
o VLAN ID - This parameter is the tagged VLAN ID that has been
configured in “Tagged VLAN Configuration”. It is a pull-down menu
showing the tagged VLAN IDs that have been defined.
o Aging Time - This parameter indicates the amount of time, in hours,
after the last IP phone's OUI was received on a port, after which this
port will be removed from the voice VLAN. The range is 1 to 120
hours.
o CoS - This parameter is CoS priority level assigned to the voice data
packets received on each voice VLAN port. For the COS priority to be
effective, QoS must be Enabled.
Click Apply to save the settings.
• In the table at the bottom of the page, The voice VLAN Auto- Detection status
is defined. From the Auto-Detection column, select one of the port rows and
then one of the following choices from the pull-down menu:
o Ignore - This parameter indicates that the setting in the All row does
not apply to the Dynamic Vlan Status field. In other words, each port
is set individually.
o Enable - The voice VLAN Auto-Detection feature is activated for the
port row selected.
o Disable - The voice VLAN Auto-Detection feature is active for the port
row selected.
Note: The voice VLAN Auto-Detection feature can only be enabled on “Not Member”
ports of the voice VLAN. Member ports cannot have the voice VLAN Auto-Detection
feature enabled. The Status column displays Static for the member ports