User's Guide

TRENDnet User’s Guide

Web Smart Switch Series

Configure the LLDP Parameter Settings

Message TX Hold Multiplier: Sets the hold multiplier value. The hold time multiplier is

multiplied by the transmit interval to give the Time To Live (TTL) that the switch

advertises to the neighbors. The range is from 2 to 10.

Message TX Interval: Sets the transmit interval, which is the interval between regular

transmissions of LLDP advertisements. The range is from 5 to 32768 seconds.

LLDP Reinit Delay: Sets the reinitialization delay, which is the number of seconds that

must elapse after LLDP is disabled on a port before it can be reinitialized. The range is

from 1 to 10 seconds.

LLDP TX Delay: Sets the value of the transmission delay timer, which is the minimum

time interval between transmissions of LLDP advertisements due to a change in LLDP

local information. The range is from 1 to 8192 seconds.

Click Apply to save the settings.

View LLDP System Information

• Chassis ID Subtype: This parameter describes the Chassis ID subtype which is

“macAddress”. You cannot change this parameter.

• Chassis ID: This parameter lists the MAC Address of the switch.

• You cannot change this parameter.

• System Name: This parameter lists the System Name of the switch. You can

assign the system name.

• System Description: This parameter lists the product name of the switch. You

cannot change this parameter

Set LLDP Port State

For each port, click the State drop-down list and choose from the following options.

• Disabled: Indicates LLDP is disabled on the port. The port cannot receive or

transmit LLDP data packets.

• RxTx: Indicates LLDP is enabled on the port. The port can receive and transmit

LLDP data packets.

• RxOnly: Indicates LLDP is enabled on the port. The port can receive LLDP data

packets.

• TxOnly: Indicates LLDP is enabled on the port. The port can transmit LLDP data

packets.

Note: You can select the row labeled ALL to apply settings to all ports.

Click Apply to save the settings.

4. At the bottom of the left hand panel, click Save.