User`s guide

TRENDnet User’s Guide TEG-082WS
© Copyright 2014 TRENDnet. All Rights Reserved. 13
Set your IPv6 settings
System > IPv6 System Settings
Use the IPv6 System Settings page to configure the IPv6 network interface,
which is the logical interface used for in-band connectivity with the switch via
all of the switch's front-panel ports. The configuration parameters associated
with the switch's network interface do not affect the configuration of the
front-panel ports through which traffic is switched or routed.
IPv6 System Settings
IPv6 State:
The IPv6 address for the IPv6 network interface is
set in auto configuration mode if this option is
enabled. The default value is. Auto configuration can
be enabled only when DHCPv6 is not enabled on any
of the management interfaces.
DHCPv6 Client:
This option only displays when DHCPv6 is enabled.
IPv6 Unicast
Address / Prefix
Length:
The IPv6 Unicast Address is an identifier for a single
interface, on a single node. A packet that is sent to a
unicast address is delivered to the interface
identified by that address. Add the IPv6 prefix and
prefix length to the IPv6 System Settings interface.
IPv6 Static
Gateway:
Specifies the corresponding Gateway of the IP
address entered into the field.
IPv6 Dynamic
Gateway:
To configure the switch to automatically obtain its IP
configuration from a DHCP server on your network.
NS Retransmit Time Settings
NS Retransmit
Time:
A constant that defines a nonzero number of
seconds between periodic re-authentication of the
client. The field is 1~3600 seconds. The default
setting is 1 second.
Link Local Address Settings
Automatic Link
Local Address:
A link local address has a prefix of FE80, is not
routable, and can be used for communication only
on the local network. Only one link local address is
supported. If a link local address exists on the
interface, this entry replaces the address in the
configuration.
Link Local
Address/Prefix
length:
Enter the Link Local Address/Prefix Length.