User`s guide

TRENDnet User’s Guide TEG-082WS

Set GVRP time settings

Bridge > GVRP > Time Settings

This section will allow you to define the GARP Join, Leave, and Leave All Time

for each port.

Note: The GARP LeaveTime must be greater than (GARP JoinTimer x2 + 10)

and the GARPLeaveAllTime must be greater than (GARP LeaveTime + 10). The

acceptable input values are multiples of 10. If you try to enter a value that is

not a multiple of 10, the value is rimmed down to the multiple of 10.

GVRP Time Settings

Port:

The port number on the switch.

JoinTime:

This parameter is the GARP Join Timer. Its range is 10

- 1073741810 milli-seconds.

LeaveTime:

This parameter is the GARP Leave Timer. Its range is 30

- 2147483630 milli-seconds. This timer must be set in

relation to the GVRP Join Timer according to the

following equation:

 GARPLeaveTimer >= (GARPJoinTimer X 2) + 10

LeaveAllTime:

This parameter is the GARP Leave Timer. Its range is 30

- 2147483630 milli-seconds. This timer must be set in

relation to the GVRP Leave Timer according to the

following equation:

 GARPLeaveAllTimer > (GARPLeaveTimer + 10)

Action:

Modifying settings in the row marked All, will apply

the settings to all ports. Click Apply to apply the

change.

Note: To ensure compatibility between network devices, you need to configure the

same values for the GARP Join Timer, GARP Leave Timer, and GARP Leave All Timer

on all participating GVRP devices in your network.

Go Save Settings to Flash section to save the change on the flash to make

sure the change is permanent.