User`s guide

TRENDnet User’s Guide TEG-082WS
© Copyright 2014 TRENDnet. All Rights Reserved. 60
To create a SNMP User and Group Name:
Note: There are no default User Name or Group Name defined for SNMP.
 Type a new User Name. Enter a name up to 31 characters in length.
 Type a new Group Name. Enter a name up to 31 characters in length.
 From the SNMP Version pull down menu, select v3. The encryption
check-box becomes active.
 Check the encryption check-box. The Auth-Protocol, Priv-Protocol,
and associated password fields become active.
 Select one of the following choices for the Auth-Protocol field:
o MD5: The MD5 authentication protocol. SNMP Users are
authenticated with the MD5 authentication protocol after a
message is received.
o SHA: The SHA authentication protocol. Users are
authenticated with the SHA authentication protocol after a
message is received.
 Enter the password for the Auth-Protocol.
 Select one of the following choices for the Priv-Protocol field:
o DES: Specifies DES encryption scrambles the SNMP data so
that outside observers are prevented from seeing the data
content.
o None: Specifies no encryption is applied to SNMP data.
 Click Add.
The new User Name and Group Name are displayed on the SNMP
User/Group page.
To modify a SNMP User and Group Name:
If you need to modify an entry in the SNMP User/Group page, you must first
delete the entry and then re-enter it.
To delete a SNMP User and Group Name:
In the Action column of the table, click Delete for the User Name and Group
Name that you want to remove.
Go Save Settings to Flash section to save the change on the flash to make
sure the change is permanent.