User`s guide

TRENDnet User’s Guide TEG-082WS

Configure the SNMP Community Table

SNMP > Community Table

A community string has attributes for controlling who can use the string and

what the string will allow a network management station to do on the switch.

The Web Management Utility does not provide any default community

strings. You must first define an SNMP User and Group Name on the SNMP

User/Group page and then define a Community Name on the SNMP

Community Table page.

To create SNMP Community Setting

 Enter a new Community Name. A name can be up to 31 characters

in length.

 Enter a User Name (View Policy) that has been previously defined.

This name must match one of the User Names displayed on the

Note: SNMP User/Group page. If you enter a user name that has not been pre-defined

on the SNMP User/Group page, the Community entry is displayed, but the

agent/manager communication fails.

 Click Add.

The values of the new Community Name and User Name are displayed.

To modify a SNMP Community Setting

If you need to modify a Community Table entry, you must first delete the

entry by using the procedure below and then re-enter it with the modification

by creating a new Community table entry.

To delete a SNMP Community Setting

To delete a Community Name, click Delete next to the entry in the table that

you want to remove.

The deleted Community Name is no longer displayed in the Community table.

No confirmation message is displayed.

Go Save Settings to Flash section to save the change on the flash to make

sure the change is permanent.